Wax heater
It has the capacity for three pots of "Nacach Wax".
Place the wax pot at one of its corners and the wax will fall naturally. Once you plug in the warmer, turn the thermostat until the light is on, approximately #4 - #5 and in a few minutes "Nacach Wax" will look almost liquid, which is the best consistency for epilating. The temperature should be kept constant, for which you must plug in the heater 20 or 30 minutes before starting your working day.
These minutes will vary according to the level of "Nacach Wax" in the heater. After this time, the wax will look as described above. You should only unplug the unit once your working day is over, without needing to switch the thermostat to 0 (zero).
More "Nacach Wax" can be added as its level decreases. It is very important to epilate with the wax at the proper temperature.
Its consistency should be almost liquid to leave a very thin coat applied on the skin, thus allowing the indicated yield. If you apply "Nacach Wax" in these conditions, your client will feel the low temperature that the product has at body contact. Always test the wax temperature on the inner part of your wrist.

Strips
They are used to remove the applied wax. Once it is saturated, it must be thrown away. Use smaller strips for the face.

Facial and body spatulas
Use one per person and throw it away at the end of the epilation.

Post-depilatory oil
This is applied once the epilation is finished. It is an excellent combination of moisturizing and soothing agents.